totalask.blogg.se

Some computers and motherboards that are not commonly used do not support the parallel ports with enough power to allow

To change the configuration of the used ports, move to the settings pageĪnd check if this port is enabled ( you can also check this with wku32.exe in the DOS-Shell).Īlso check the port Adresse (disable system standard). Ĭheck if used port is shown on the contents page in our WIBU-KEY Control Panel. The configuration of the ports can be checked in the system control panel. If there are arrows on the WIBU-BOX case, these must point in the direction of the computer. Under Mac OS X and Linux you can test the drivers by using the WkConfig tool or by using WKU in the shell.Ī WIBU-BOX/P must be attached to a parallel port and a WIBU-BOX/SP must be attached to a serial port. Even if they do not find WIBU-BOXes,īoth programs should start without any error message. You can test these drivers by opening the WIBU-KEY Control Panel Applet or by using WKU32.EXE in the DOS-Shell.īoth programs should detact and list all the WIBU-BOXes attached to the local system. Is a printer attached to the same port as the WIBU-BOX?ĭoes the system correctly recognize the WIBU-BOX/U?ĭiagnosis possibilities of the WIBU-KEY driverĪre all required driver files installed correctly? Is the WIBU-BOX attached to the proper port?ĭoes the computer recognize the ports and their I/O addresses correctly?Īre you using a special kind of computer or special kind of motherboard?

The following activities need to be double-checked: Are all required driver files installed correctly? the WIBU-BOX cannot be detected by the driver.

the WIBU-KEY driver is not installed properly and/or not configured properly or hardware problems, i.e. These reasons result from two main categories of problems: software problems, There may be various reasons why a WIBU-BOX is not detected. Problems with localy connected WIBU-BOXes.